155
Creating and Editing Keyframes
Chapter 11 Keyframes
3
Using image transformations or adding special effects,
modify the keyframe.
4
Press the [MOD] button.
Modifying more than one keyframe
simultaneously
You can modify a number of keyframes simultaneously.
There are three different operating procedures.
• Modifying from the edit point to a particular keyframe
• Modifying all keyframes in the effect
• Modifying the keyframes in a specified range
The different procedures for these cases are now
described.
To modify from the edit point to a particular
keyframe
1
Press the [EFF] button, then press the [EDIT ENBL]
button, turning it on.
2
Stop the effect at the first keyframe of the range to be
modified.
3
Carry out the necessary modifications.
4
Press the [FROM TO] button.
This switches the memory recall section to numeric
keypad entry mode.
The alphanumeric display shows the current keyframe
number and the indication “TO.”
5
Enter the number of the last keyframe to be modified
from the numeric keypad and press the [ENTR] button
to confirm.
The [FROM TO] button lights green.
6
Press the [MOD] button. Alternatively, hold down the
[SHFT] button and press the [MOD] button.
For the difference in the result, 1 “Differences in the
changes when a number of keyframes are modified”
(p. 155).
To modify all keyframes in the effect
1
Press the [EFF] button, then press the [EDIT ENBL]
button, turning it on.
2
Carry out the necessary modifications on any
keyframe.
3
Press the [ALL] button, turning it on green.
4
Press the [MOD] button. Alternatively, hold down the
[SHFT] button and press the [MOD] button.
For the difference in the result, 1 “Differences in the
changes when a number of keyframes are modified”
(p. 155).
To modify the keyframes in a specified range
1
Press the [EFF] button, then press the [EDIT ENBL]
button, turning it on.
2
Stop the effect at any keyframe within the range to be
modified.
3
Carry out the necessary modifications.
4
Press the [FROM TO] button.
This switches the memory recall section to numeric
keypad entry mode.
The alphanumeric display shows the current keyframe
number and the indication “TO.”
5
Carry out the following operations.
• To set the first keyframe in the range to be modified,
press the [CLR] button, then enter the keyframe
number using the numeric keypad buttons, and press
the [ENTR] button to confirm.
• To set the last keyframe in the range to be modified,
enter the keyframe number using the numeric
keypad, and press the [ENTR] button to confirm.
The [FROM TO] button lights green.
6
Press the [MOD] button. Alternatively, hold down the
[SHFT] button and press the [MOD] button.
For the difference in the result, 1 “Differences in the
changes when a number of keyframes are modified”
(p. 155).
Differences in the changes when a number
of keyframes are modified
When you select a number of keyframes to modify, and
press the [MOD] button alone or in combination with the
[SHFT] button, the result of the operation differs as shown
below.
Modifying the keyframes by pressing the [MOD]
button alone
The modified parameter values are taken as absolute
values, and applied to all of the selected keyframes.
To Next Page
Loading...
