of the ~Q~~ow~g
g the receiver, use this
: to help you remedy the
Checking the connections”
hat the connectians are
roMenn persist, consult
der.
CTER VOLUME contra! is
: MIN.
4KBRS .4/B button is not set
*’ and is set accordingly to
ROiVT system (page 27).
mcel the nlutti~ function.
phones are not cbonnected.
:e cm the receiver has been
f a short circuit PPROTECT:
e receiver, eli&nate the
n and turn on the power
n s specitic 05~~Q~S~~.
loned is connected correctly
.cks for that component.
;s) used for the connection is
nto the jacks cm both the
nponent.
: selected rhc correct
xeiver.
--
Connect a pair of headphones to the PHONES jack
to verify that sound is output from the headphones
(page 27).
If only one channel is output from the headphones,
the component may not be connected to the
receiver correctly. Check that all the cords are fully
inserted into the jacks on both the receiver and the
component.
If both channels are output from the headphones,
the front speaker may not be connected to the
receiver correct&. Check the connection of the
front speaker which is not outputting any sound.
me I&f and right sasunrgs are w&xdence?d or
rewsrsed.
0 Check that the speakers *and components sre
connected correctly and securely.
Q Adjust balance parameters in the LEVEL menu.
--
mere IS sewere kwm c?r misc.
- Check that the speakers and components are
connected securely.
* Check that the connecting cords are away from a
transformer or motor, and at least 3 meters away
from a TV set or fluorescent Iight.
* Move your TV away from the audio components.
- Make sure you have grounded ij, SIGNAL GK;D
terminal (only when a tumtabIe is connected).
- The plugs and jacks are dirty. Wipe them with a
cloth slightly moistened with alcohol.
..-
- Make sure the sound field function is on (press
MODE (SOliinrD FIELD)).
* Select a sound field containing the word
“CINEMA STUDIO EX’: (pages 29-30).
* Adjust the speaker level (page 25).
0 Make sure the center or/and surround speaker
size parameter is set to either “SNt4LL” or
“LARGE” (page 21).
0 Check that the playing DVD, etc. is recorded in
Dolby Digital or DTS format.
- When connecting the DVD player. etc. to the
digital input jacks of this receiver, check the
audio setting (settings for the audio output) of the
connected component.
Remxding cannot be &me.
* Check that the components are connected
correctly.
e*S,elect the source component with FUNCTION
control.
* Make sure that INYii MODE is set to
“ANAIDG 2CH FIXED” before recording from
a digital component connected to the analog
MDlDAT or TAPE terminals (STR-DE985) or
the analog MDfTAPE terminals (STR-DE885).
0 Make sure that INPUT MODE is set to
“COAXIAL FIXED” or YF’IZ4L FIXED”
(page 26) before recording from a digital
component connected to the DIGITAL
MIYDAT OUT terminals (STR-DE%%) or the
DiGITAL MD/TAPE OUT terminals
(STR-DE885).
~ . . . .._
There Is ne, swnd from the actlwe sub QmQfer.
There is no sound output from the SUB WOOFER
terminal depending on the sound field (page 67).
The s.wrrownrB effect canna be ~~tai~e~.
Make sure the sound field function is on (press
MODE (SOUND FIELD)).
To Next Page
Loading...
