Sony XVS-G1

106
You can set the operation mode for executing a transition
when releasing a pattern limit to manual or auto.
For details about setting the ope
ration mode, see “Setting
the Operation Mode W
hen the Pattern Limit is Released”
(page 393).
1 Press the [PTN LIMIT] button in the transition
control block/transition control block (simple type).
The [PTN LIMIT] butt
on is lit green.
2 Execute a transition.
If the operation mode when a
pattern limit is
released is set to auto
Press the [PTN LIMIT] button to execute the
rema
inder of the transition automatically with the
preset transition rate. When the transition is
completed, the pattern limit is released and the [PTN
LIMIT] button turns off.
If the operation mode when a
pattern limit is
released is set to manual
Execute the remainder of the transition using one of
t
he following methods. When the transition is
completed, the [PTN LIMIT] button turns off.
• Press the [CUT] button.
The image switches instantaneously and the pattern
limi
t is released.
• Press the [AUTO TRANS] button/[TAKE] button.
The remainder of the transiti
on is executed with the
preset transition rate and the pattern limit is
released when execution is completed.
• Operate the fader lever.
If the fader lever is moved in the execution
dire
ction of the transition, the remainder of the
transition is executed and the pattern limit is
released when execution is completed.
If the fader lever is moved in the opposite direction,
the
transition is executed such that the state before
executing the transition is restored, and the pattern
limit is released when execution is completed.
To set the transition rate when the pattern limit
is releas
ed
This section describes the M/E-1 menu as an example.
1 Open the pattern limit setting menu.
When the transition type is a
wipe, open the Home >
M/E-1 > Bus/Transition > Wipe > Pattern Mix/Edge/
Direction menu (11109.33).
When the transition type is a DME wipe, open the
Home
> M/E-1 > Bus/Transition > DME Wipe >
Edge/Direction menu (11109.44).
2 Set the transition rate in the [Pattern Limit Release]
group.
Auto Trans Rate:
Follow the current transition rate.
Independ Trans Rate: Set
an independent transition
rate for releasing a pattern limit.
When the [Independ Trans Rate] button is selected,
set t
he following parameter.
No. Parameter Adjustment
1 Transition Rate Transition rate when the
pa
ttern limit is released