Sony XVS-G1

113
Executing an independent key transition
(key fader control block)
You can execute an independent key transition for a key
assigned to a key delegation button.
For details about assigning key delegation buttons, see
“Assigning Control Panel Buttons” (page 397).
To insert/remove a key instantaneously
Press the [KEY ON] button.
The [KEY ON] button label indicates the key assigned to
the key d
elegation button.
To insert/remove a key with the preset transition
type and
transition rate
Press the [AUTO TRANS] button
for the corresponding
key.
During the transition execution,
the button is lit amber
and goes off when the transition is completed.
• You can change this so that du
ring the execution of the
transition, the button is lit green and when the transition
is completed it is lit red if on-air or lit amber if not on-
air.
For details about settings, see “Setting the independent
key transition, auto transition execution button
display” (page 412).
• When a cut is selected as the transition type, the key is
i
nserted/removed instantaneously.
To insert/remove a key manually with the preset
tr
ansition type
Operate using the fader lever.
You can set the key which is the target of fader lever
operat
ion.
For details about setting t
he fader lever, see “Assigning
Control Panel Buttons” (page 397).
Executing an independent key transition
(menu)
This section describes the M/E-1 key 1 menu as an
example.
1 Open the Home > M/E-1 > Key1 > Key Snapshot
menu (11101.71).
2 Execute a transition.
To insert/remove a key instantaneously
Press the [KEY ON] button.
To insert/remove a key with the prese
t transition
type and transition rate
Press the [KEY TRANS] button.
When a cut is selected as the transition type, the key
is in
serted/removed instantaneously.
Note
Notes
Note
Note