Sony XVS-G1

286
Saving a Snapshot
Switcher bank region snapshot
The same memory recall buttons as in the memory recall
section of the Flexi Pad control block are displayed in the
Common > Snapshot menu of the switcher bank. The
settings and display of the memory recall buttons in the
Flexi Pad control block and in the menu are linked.
This section describes the M/E-1 menu as an example.
Set the state to save in a snapsh
ot and use the following
procedure to save in a snapshot register.
1 Open the Home > M/E-1 > Common > Snapshot
menu (11110.21).
2 Press the [Store] button in the [Mode] group.
3 Press the [Bank] button and enter a bank number in
the numeric keypad window.
The memory recall section switches to display the
selected bank.
4 Press the button for the target register to save.
The register button is lit orange and
the snapshot is
saved.
If you press a register button in which a snapshot is
a
lready saved, the register data will be overwritten.
5 Set attributes.
Set attributes for a register as required.
To add the auto transition attribute
Set the [Auto Transition] button to the on state.
To add the effect dissolve attribute
Set the [Activate] button in the [Effect Dissolve]
g
roup to the on state.
Press the [Duration] button in the [Effect Dissolve]
gro
up and enter a duration (number of frames) for the
effect dissolve in the numeric keypad window.
To add the cross-point hold attribute
In the [Xpt Hold] group, set t
he button for the target
bus to the on state.
A: Ba
ckground A bus
B: Back
ground B bus
Utility 1: Ut
ility 1 bus
Utility 2: Ut
ility 2 bus
DME External: DM
E external video bus
Key 1 to Key 8:K
ey 1 bus to key 8 bus
To delete a register
A locked register cannot be deleted.
1 Press the [Delete] button in the [Mode] group.
2 Select a bank and press the button for the target
register to delete.
To rename a register
A locked register cannot be renamed.
1 Press the [Rename] button in the [Mode] group.
2 Select a bank and press the button for the target
register to rename.
The [Rename] window appears.
3 Press the input field and enter a name (up to 8
characters) using the keyboard.
4 Press [OK].
Snapshot for a region other than a
switcher bank
Set the state to save in a snapshot and use the following
procedure to save in a snapshot register.
1 Display the [Snapshot] taskbar.
Snapshot recall/store mode is activated.
2 Press the [Recall/Store] button.
The [Recall/Store Register] window appears.
3 Set the button for the target region to the on state.
You can select multiple regions.
For details about the display in the region display
section, see “Region display section” (page 285).
Select a tab to change the region to display.
[ME] tab:
Switcher bank regions
[User] tab: U
ser regions
[DME] tab: DME
regions
[External Device] tab:
External device regions
The first selected region becomes the re
ference
region.
Note
Note
Note