Sony XVS-G1

285
3 Press the [Bank] button and enter a bank number in
the numeric keypad window.
The memory recall section switches to display the
selected bank.
4 Press the button for the target register to recall.
The register button is lit orange and
the snapshot is
recalled.
Snapshot for a region other than a
switcher bank
1 Display the [Snapshot] taskbar.
Snapshot recall/store mode is activated.
2 Press the [Recall/Store] button.
The [Recall/Store Register] window appears.
3 Set the button for the target region to the on state.
You can select multiple regions.
For details about the display in the
region display
section, see “Region display section” (page 285).
Select a tab to change the region to display.
[ME] tab: Switch
er bank regions
[User] tab: User region
s
[DME] tab: D
ME regions
[External Device] tab: E
xternal device regions
The first selected region becomes the reference
region
.
To select all regions configured beforehand
Set the [All Regions] button to the on state.
For details about setting the regions selected
si
multaneously, see “Setting Regions Selected
Simultaneously” (page 397).
The region selection is common for
snapshots and
effect timelines.
4 Press the [Recall] button.
5 Enter a register number in the numeric keypad area.
For details about selecting a register, see “Selecting
a register” (page 285).
To add the auto transition temporary attribute
Set [Auto Trns] in the numeric keypad area to the on
state.
To add the effect dissolve temporary
attribute
Set [Effect Diss] in the numeric keypa
d area to the on
state.
In the [Recall/Store Register] window, it is not
po
ssible to add the cross-point hold temporary
attribute.
You can use the bus override function and the cross-
point butt
on row cross-point hold function.
For details, see “Cross-Point Hold” (page 89).
6 Press [Enter].
The specified register is recalled.
To undo a register recall
To undo a recall immediately
after recalling a register,
press the [Undo] button.
To set the duration for an effect dissolve
temporary attribute
You can set the duration for an effect dissolve temporary
at
tribute for each region.
Select the target region to set, press the [Temp Diss
Du
ration] button, and enter a duration (number of frames)
for the effect dissolve in the numeric keypad area.
Selecting a register
Select a register using the numeric keypad area at the
b
ottom right of the [Recall/Store Register] window.
Enter a register number in the numeric keypad area and
pr
ess [Enter] to apply the setting.
When you enter a register number, the register number
and
the following information appears on the numeric
keypad area display.
e: The register is empty for the currently selected region.
E: The register is empty for all selectable regions.
L: The register is locked.
To search for an empty register, press [.] (period).
To search for an empty register common to all selectable
region
s, press [.] (period) again.
Searching for an empty
register is enabled only when
saving a snapshot.
Region display section
The region display section at the top ri
ght of the [Recall/
Store Register] window shows the region selection status.
The selected regions are displa
yed in white characters.
The reference region is displayed highlighted.
Note
Note
Note