32
b Independent key transition execution section
The four [KEY ON] buttons and [AUTO TRANS]
bu
ttons correspond to the keys assigned to key delegation
buttons 1 to 4.
The [KEY ON] button label indicates the key assigned to
the key d
elegation button.
c Independ
ent key transition type selection buttons
d K
ey snapshot operation buttons
e Display
Displays the following informa
tion for each key assigned
to a key delegation button.
• Key content name (key source name when a key source
i
s selected on a cross-point control block key bus)
• Currently used DME channel or resizer
• Transition rate
• Transition type
• Register name (in key snapshot operation mode).
Name Description
Fader lever Move this up or down to execute a
transi
tion.
Transition indicator Displays the transition progress
using LEDs.
[KEY ON] button Inserts or removes a key
i
nstantaneously.
When a key is currently inserted,
the
button is lit amber.
[AUTO TRANS]
bu
tton
Inserts or removes a key
automatically with the set transition
rate and transition type.
During the transition, the button is
l
it amber.
Note
Button name Description
MIX Selects mix.
WIPE Selects wipe.
DME WIPE Selects DME wipe.
CUT Selects cut.
SHIFT Use when setting transitions separately for
key insertion
and removal.
Transition indicator
KEY ON buttons
AUTO TRANS buttons
Fader lever
Button name Description
K-SS 1 to
K-SS 4
Selects key snapshot register 1 to 4.
K-SS Switches to key snapshot o
peration mode.
K-SS STORE Saves a key snapshot in the selected
re
gister when a [K-SS 1] to [K-SS 4] button
is pressed while pressing the [K-SS
STORE] button.
UNDO Undoes a key snapshot recall if pressed
immediately after the recall.