Sony XVS-G1

50
Flexi Pad Control Block
The Flexi Pad control block is used for recalling and
saving snapshots, wipe snapshots, DME wipe snapshots,
and key snapshots, for recalling and creating macros, for
recalling shotboxes, for entering the transition rate, and
for other tasks.
a Mod
e selection buttons / operation buttons / bank
selection buttons (assignable buttons)
You can assign mode/bank selection buttons and
o
peration buttons in the Home > Setup > Panel > Module
> Button Assign menu (19104.21).
For details about assign
ing buttons, see “Assigning
Control Panel Buttons” (page 397).
Mode selection buttons
[UNDO] button / [DEL] button
Function
name
Button name Description
Key KEY Switches to key operation
mode.
In key operation mode,
you can car
ry out the
following operations.
• Saving and recalling key
snap
shots
• Selecting independent
key transition type
• Selecting the key fill
signal or key
source
signal in the cross-point
control block
a
b
Wipe WIPE Switches to wipe
snapshot operation mode.
In wipe snapshot
ope
ration mode, you can
save and recall a wipe
snapshot and select a
wipe pattern.
DME Wipe DME WIPE Switches to DME wipe
snap
shot operation mode.
In DME wipe snapshot
ope
ration mode, you can
save and recall a DME
wipe snapshot and select
a DME wipe pattern.
Snapshot SNAPSHOT Switches to snapshot
ope
ration mode.
In snapshot operation
mode
, you can save and
recall snapshots, and add
attributes.
Shotbox SHOTBOX Switches to shotbox
ope
ration mode.
In shotbox operation
mode
, you can recall and
execute shotboxes.
Macro MCRO Switches to macro
ope
ration mode.
In macro operation mode,
press and
hold the
[MCRO] button and press
a button (for the target
register) in the memory
recall section to enter edit
mode.
In macro operation mode,
you can
save, recall, and
edit macros.
Transition Rate TRANS RATE Switches to transition rate
ope
ration mode.
In transition rate operation
mode
, you can enter a
transition rate.
Function
name
Button name Description
Undo UNDO After recalling a register,
returns to the state before
the register was recalled.
Delete DEL Press and hold the [DEL]
button an
d press a
register button in the
memory recall section to
delete the register data.
Function
name
Button name Description