Digital Video Recorder
95
System Log Notices
Boot Up Setup Export Failure Clip-Copy Fail
Shutdown Setup Export Cancel Clip-Copy User:
Restart Schedule On Clip-Copy From:
Upgrade Schedule Off Clip-Copy To:
Upgrade Fail Panic On Clip-Copy Duration of Video:
Power Failure Panic Off Clip-Copy Camera:
Time Change Clear All Data Callback Fail
Time Zone Change Clear Disk Print Begin
Time Sync Format Disk Print End
Time Sync Fail Disk Full Print Cancel
Disk Bad Disk Config Change Archive On
Login No storage found Archive Off
Logout Disk Added Mirror 1 (2) Started
Setup Begin Disk Removed Mirror 1 (2) Start Failed
Setup End Auto Deletion Mirror 1 (2) Stopped
Remote Setup Change Search Begin Mirror 1 (2) Stop Failed
Remote Setup Failure Search End Factory Reset
Setup Imported Clip-Copy Begin Login : VNC (server address)
Setup Import Failure Clip-Copy End Logout : VNC (server address)
Setup Exported Clip-Copy Cancel
Troubleshooting
Problem Possible Solution
No Power
Check power cord connections.
Confirm that there is power at the outlet.
No Live Video
Check camera video cable and connections.
Check monitor video cable and connections.
Confirm that the camera has power.
Check camera lens settings.
Live Video Very Bright
If a cable is attached to the “Loop” connector, make certain it is connected to a
properly terminated device.
DVR has stopped recording
If hard disk drive is full, you will either need to delete video or set the DVR to the
Overwrite Mode.
The icon displays,
however, the DVR is not
recording.
When the DVR is in the Pre-Event recording mode, the yellow
and
display
when there is no event, and the DVR is not recording. The red
and
display
when any event occurs and the DVR starts recording.
While upgrading the system,
the DVR keeps rebooting and
the upgrade fails.
If the current system version is higher than the upgrade package file version, you
should reset the DVR first using the Factory Reset. When using the Factory Reset,
you will lose any settings you have saved.
To Next Page
Loading...
