Speco D12LX - Network Camera; Figure 43: Camera - Network Camera Setup Screen

Digital Video Recorder
57
Highlight the box in the Product column for the PTZ camera you wish to configure
and press the
button. A list of PTZ devices appears. Select your camera
from the list and press the
button. You will need to connect the camera to
the RS232 or RS485 connector on the back of the DVR following the camera
manufacturer’s instructions.
You can assign IDs to each camera by highlighting the box under the ID heading and pressing the button. Change
the number by highlighting it and using the Up and Down arrow buttons to increase and decrease the number. The
PTZ ID number can be set from 0 to 256.
Highlight the Setup… box and press the button. The Port Setup window appears.
Configure the port’s setting based on the PTZ camera manufacturer’s instructions.
Network Camera
Highlight Network Camera and press the button, and the Network Camera setup screen appears. (Network Devices
Only)
NOTE: “Network Camera” includes both network cameras and network video transmitters.
Figure 43 : Camera – Network Camera setup screen.
Highlight the Scan… box and press the
button, and the Device Scan setup screen appears.