Operation Instruction
72
Highlight the box beside Check Time Overlap and press the
button. It toggles between On and Off. You will only
be able to turn the Check Time Overlap on or off if a user-defined date and time is set to From and To. If the DVR’s
date and time have been reset, it is possible for the DVR to have more than one overlapping start and stop time. When
set to On, you will be asked to select one of the overlapping start and stop time. When set to Off, the DVR will display
search results from all start times to all stop times.
Highlight the box beside Alarm-In and press the button. You can select the alarm inputs that you want to include
in your search.
Highlight the box beside Motion and press the button. You can select the cameras for which you want any reports
of motion detection.
Highlight the box beside Video Loss and press the button. You can select the cameras for which you want any
reports of lost video.
Highlight the box beside Video Blind and press the button. You can select the cameras for which you want any
reports of blind video.
Highlight the box beside Audio Detection and press the button. You can select the cameras for which you want
any reports of audio input. (Network Devices Only)
Highlight the box beside Trip-Zone and press the button. You can select the cameras for which you want any reports
of trip-zone. (Network Devices Only)
Highlight the box beside Tampering and press the button. You can select the cameras for which you want any
reports of tampering. (Network Devices Only)
Highlight the box beside Text-In and press the button. You can select the text-in devices which you want any reports
of text input.
Highlight the box beside Record Channels and press the button. You can select the cameras that you want to search
for any reports of event recorded data. The DVR will display the events (not the camera channels) that occurred and
that also are recorded on the camera channel that you selected. If you do not select a camera channel in this field, the
DVR will search events that are not associated with cameras.
You can also toggle On and Off self-diagnostic System Events as part of your search. The choices are:
Panic Record
Check Recording
Check Alarm-In
Disk Almost Full
Disk Bad
Disk Temperature
Disk S.M.A.R.T.
Fan Error
Disk Added/Removed
Disk Config Change
Once you set your desired search conditions, highlight Search and press the button to display the search results in
the Event Log Search screen. Selecting Cancel exits the screen without saving the changes.
To Next Page
Loading...
