SpectraLink 6500 - Configuring a Spectralink IP-DECT Server 6500 Using Static IP Address

Spectralink IP-DECT Server 6500 Installation and Configuration Guide
14215700 Version 3.0
April, 2014 42
Configuring a Spectralink IP-DECT Server 6500 Using
Static IP Address
This section describes how to configure a Spectralink IP-DECT Server 6500 using a static IP
address.
Figure 19 Spectralink IP-DECT Server 6500 installation
General Configuration
On the Configuration/General page you define IP, DNS and NTP settings for the Spectralink
IP-DECT Server 6500.
1 Click Configuration, and then click General.
Note
Because the Spectralink IP-DECT Server 6500 is a critical part of the SIP infrastructure, it is
highly recommended that you do not use DHCP. Using a static IP adress is the preferred
method.