SpectraLink 6500 - Page 48

Spectralink IP-DECT Server 6500 Installation and Configuration Guide
14215700 Version 3.0
April, 2014 46
Client transaction
time-out (msec)*
Client transaction time-out. This
controls timer B and F as specified in
RFC3261. Increase this to eliminate time
out errors or decrease it to reduce fail
over time.
Default value: 4000ms
x
SIP type of service
(TOS/Diffserv)
TOS/Diffserv used for SIP signaling.
Enter in decimal.
Default setting: 96
x
SIP 802.1p
Class-of-Service*
This is the 802.1p PCP and must be
between 0 and 7. The setting requires
VLAN tagging.
Default value: 3
x
GRUU Enable Globally Routable User Agent
URIs.
Default value: Enabled
x
Use SIPS URI Normally SIP communication on a TLS
connection uses the SIPS: URI scheme.
Disabling this option causes the KWS to
use the SIP: URI scheme with a
transport=tls parameter for TLS
connections.
Default value: Enabled
x
TLS allow insecure **By default UDP and TCP transports are
disabled when TLS transport is the
default. If this setting is enabled, UDP
and TCP are allowed as fallback if TLS
fails.
Default value: Disabled
x
Proxy Enter SIP proxy.
The proxy is the SIP URI of the
SIP-proxy. The IP-DECT Server 400 will
route all outgoing SIP signalling to the
proxy, e.g. SIP registrations and
outgoing calls.
x
SIP Configuration - Proxies
Proxy 1-4 Priority: The priority for using this proxy.
Possible Value 1-4.
Weight: The weight for using this proxy if
more proxies have the same priority.
Possible value 1 - 65.000 higher weight
gives priority.
Default value: 100.
URI: The URI or IP address of the proxy
x
Field Explanation Required Optional