spencer 2022A user guide spencerhealthsolutions.com 76
Device Usage This device is not intended for critical life sustaining medications.
Contact your healthcare provider for any health-related questions.
Instructions Follow all instructions. The operator should read and understand this entire
manual before using the device.
Operating Conditions Do not place SmartHub near any heat sources such as radiators, heat
registers, stoves or other equipment that produces heat or in direct sunlight.
To reduce the risk of electrical shock or fire, do not place the SmartHub in
or near water or other liquids, or expose it to rain.
Do not remove any exterior covers from the SmartHub.
Do not remove the spencer refill cover.
Do not insert hands, fingers or other foreign objects inside the SmartHub
while it is powered.
Keep out of the reach of small children. Close supervision is required when
this product is used near children.
Improperly Functioning Device If you notice any unexplained changes in the performance of the SmartHub,
if it is making unusual sounds, if water is spilled into the SmartHub, or if the
enclosure is cracked or broken, discontinue use and contact Customer Care
immediately.
Power Cord To avoid strangulation hazards, ensure that the power cord connected to
the SmartHub is routed properly. Use the included wire tie to keep the cord
as short as necessary.
Route the power cord in a way that will prevent it from being tripped over or
interfered with by chairs or other furniture.
The power plug is the main means of disconnecting this SmartHub. Install
this SmartHub so that the power plug can be easily unplugged from the
outlet if necessary.
Do not plug the SmartHub into an electrical outlet that is controlled by a wall
switch, as someone could accidentally turn off the power.
Do not modify the power plug or cord in any way. If the plug does not fit into
your outlet, consult with an electrician to update your outlet.
Accessories Only use manufacturer approved accessories with this device.
The USB charging port on the back of the SmartHub is designed only for
use in charging mobile devices equipped with a USB charger. Only connect
a single device at a time to the charge port.
To Next Page
Loading...
