STEMME S12

DOCUMENT NUMBER:
L500-912.820 ISSUE JUL 20, 2016
AMENDMENT: 00
DATE: 
CHAPTERPAGE 015
MAINTENANCE MANUAL STEMME S12
5.4.20 Electric System (except for engine and TCU). .................................................. 5-35
5.4.21 COM and NAV Equipment. ............................................................................ 5-35
5.4.22 Completion Tasks. ....................................................................................... 5-36
5.4.23 Optional Equipment. ................................................................................... 5-37
5.5 Special Inspections. .....................................................................................5-39
5.5.1 Inspection Following a Heavy Landing or a Wing Tip Landing. ............................ 5-39
5.5.2 Inspection Following an Impact to the Rotating Propeller. ................................. 5-39
5.5.3 Inspection following Exceptional Events with Wing Folding Device. .....................5-40
6. Maintenance Instructions, Tolerances, Adjustment Data for the Aircraft................ 6-1
6.1 General Remarks. .........................................................................................6-1
6.2 Towing on ground, Jack Points and Lifting. .......................................................6-1
6.3 Determination of Empty Weight and Corresponding
Center of Gravity; Weight Limits. .....................................................................6-3
6.4 Flight Control System. ................................................................................... 6-8
6.4.1 Deection of Control Surfaces, Control System Friction, and Control Forces. ......... 6-8
6.4.1.1 Control Surface Deections. .......................................................................... 6-8
6.4.1.2 Friction in Control System. ............................................................................. 6-9
6.4.1.3 Pilot Forces. ................................................................................................ 6-9
6.4.2 Weights and Moments of Control Surfaces...................................................... 6-10
6.4.3 Free Play in Flight Control System. ................................................................. 6-10
6.5 Lubrication. ................................................................................................6-11
6.5.1 General Remarks. ........................................................................................6-11
6.5.2 Lubrication Plan. ........................................................................................ 6-12
6.6 Surface of Composite Structures. .................................................................. 6-13
6.7 Drainage and Ventilation Holes. .................................................................... 6-15
6.8 Tightening Torques of Screwed Joints. ............................................................ 6-15
7. Maintenance Instructions, Tolerances and Adjustment
Data for Assemblies / Equipment. .................................................................... 7-1
7.1 Airframe. ..................................................................................................... 7-1
7.1.1 Wing. .......................................................................................................... 7-1
7.1.1.1 Cracks and Structural Damage. ...................................................................... 7-1
7.1.1.2 Drainage and Ventilation Holes. ...................................................................... 7-1
7.1.1.3 Wing Fittings. ............................................................................................... 7-1
7.1.1.4 Flaps and Ailerons. .......................................................................................7-2
7.1.2 Fuselage. .....................................................................................................7-3
7.1.2.1 Cracks and Structural Damage. ......................................................................7-3
7.1.2.2 Drainage Holes. ............................................................................................7-3
7.1.2.3 Nose-cone. ..................................................................................................7-3
7.1.2.4 Center Fuselage. ...........................................................................................7-4
7.1.3 Empennage. .................................................................................................7-4
7.1.3.1 General Condition. ........................................................................................7-4
7.1.3.2 Vertical Tail. .................................................................................................7-5
7.1.3.3 Horizontal Tail. .............................................................................................7-6
7.1.3.4 Weights and Static Hinge Moments of Control Surfaces. .....................................7-6