STEMME S12 User Manual

DOCUMENT NUMBER:
L500-912.820 ISSUE JUL 20, 2016
AMENDMENT: 00
DATE: 
CHAPTERPAGE 58
MAINTENANCE MANUAL STEMME S12
5.3.1 INSPECTION INTERVALS
The reasonable intervals for general maintenance depend on operating conditions, climate, han-
garage, etc. The types and intervals of the minimum scheduled maintenance established for the
S12 are indicated in the table below.
ANNUAL INSPECTIONS
The motorglider must undergo a complete inspection each 12 calendar months. The inspection has
to be carried out according to applicable national requirements by an authorized maintenance
person. A signed and dated record must be maintained as each inspection task is completed.
When all inspections have been completed, the Inspection Report shall be signed o in the Log
Book or Maintenance Record according to applicable national requirements in order to release
the aircraft into service.
This Chapter of the Maintenance Manual summarizes the inspection items that must cover in
each Annual Inspection. Annual Inspection items listed below in section 5.4 cover in scope to
the inspection items required in the 100 hours inspection.
100 HOURS INSPECTIONS AIRFRAME
In addition to the annual inspection specic inspection tasks are required also every 100 hours of
ight operating time.
The aircraft’s mandatory Annual Inspection also covers the scope of the 100 hours inspection
detailed in table 5.4. The 100 hours interval between inspections must not be exceeded by
more than 10 hours. This tolerance is reserved to reach a location where the inspection can be
satisfactorily accomplished.
The time by which the inspection interval was exceeded must be included as ight hours in the
next 100 hr interval. For example, if a 100 hr inspection was due at 650 hours of ight and was
actually signed o at 658 ight hours, the next 100 hours inspection is due at 750 ight hours,
not at 758 hours of ight. Inspection tolerances may not be accumulated.
100, 200, 600 ENGINE OPERATING HOURS INSPECTIONS
Additional periodic inspections must be performed every 100, 200 and 600 engine operating
hours. They have to be carried out in accordance with the following Periodic Inspections Check
List, chapter 5.4.

STEMME S12 Specifications

General

Brand	STEMME
Model	S12
Category	Aircrafts
Language	English