Steris 4085 - 7 Disposal Hazards

7-1
Disposal Hazards Operator Manual 150832-639
The following materials may be contained within the table. When
disposing of the table or its parts, ensure the proper disposal of
hazardous and other regulated waste in compliance with federal, state
and local regulations.
Lead Acid (Pb/H
2
SO
4
): gelled cell batteries located in the table base
at the head end of the table. Approximate weight 5 lb (2 kg).
Lead (Pb) in Solder: contained in solder on circuit boards and in
some miscellaneous wire connections. Minute amounts.
Electronic and Electrical Parts: not known to require special
disposal at date of this manual.
Metal Parts: made from aluminum (Al), steel (Fe), cast iron (Fe),
copper (Cu), and copper alloys (Cu/x), plastic, synthetic rubber,
plating (Cr, Ni, Zn, Au), and adhesives not known to require special
disposal methods at date of this manual.
Hydraulic Oil: contained in hydraulic components located in the
base, column, leg section, back section, and hydraulic system lines
and hoses.
WARNING – DISPOSAL
HAZARD: This product
contains materials which may
require disposal through
appropriately licensed and
permitted hazardous waste
management firms.
CAUTION – POSSIBLE
EQUIPMENT DAMAGE: Use of
incorrect hydraulic oil may
severely damage the table
and/or cause malfunction.
Contact STERIS for proper
hydraulic oil.
DISPOSAL HAZARDS
7