4-7
Washer Operation Operator Manual 122997-341
CYCLE 10 (G=)141.5F
RECIRC./HEATING T= 5:00
NOTE: Control alternates between these display screens every
four seconds during recirculation. Displayed time only counts
down when solution temperature is equal or greater than
setpoint.
>> Alkaline detergent is injected into sump. If temperature is
guaranteed, actual sump temperature alternates with
guaranteed set temperature. Display shows:
CYCLE 10 (G=)141.5F
INJECTING ALK. T= 5:00
NOTE: Control alternates between these display screens every
four seconds during recirculation. Displayed time only counts
down when solution temperature is equal or greater than
setpoint.
>> Detergent solution is recirculated through oscillating jet
system for programmed amount of time. If temperature is
guaranteed, actual sump temperature alternates with
guaranteed set temperature. Display shows:
CYCLE 10 (G=)140.4F
ALKALINE WASH T= 5:00
NOTE: Control alternates between these display screens every
four seconds during recirculation. Displayed time only counts
down when solution temperature is equal or greater than
setpoint.
Printer records time and solution temperature in chamber sump
at beginning and end of recirculation:
ALK. WASH 10:21:55A 141.5
10:26:55A 140.2
• TIME-BASED pH NEUTRALIZATION (Option)
Alkaline neutralizer is injected during programmed amount of
time. If temperature is guaranteed, actual sump temperature
alternates with guaranteed set temperature. Display shows:
CYCLE 10 (G=) 167.8
ALK.NEUTRALIZE T = 2:00
• CONTROLLER-DRIVEN pH NEUTRALIZATION (Option)
>> pH analyzer is initialized. Display shows:
STANDBY
NEUTRALIZING SUMP
>> pH analyzer checks to see if value is within limits. Display
shows:
CHECKING pH
pH = XX.XXX
To Next Page
Loading...
