Safety 2
General safety information
General safety information
• Essentially, all safety information located
on the truck must be observed.
• Missing or illegible safety information is to
be changed.
• When cornering and driving pas
t parts of
buildings that restrict vis
ibility, use the horn
to warn others that the truck
is approaching.
• If the driver’s view is obstructed, e.g. due to
a bulky load, a guide must patrol the route
to ensure safety.
• When driving through doorways and under
ceiling joists, take the height of the truck into
consideration.
• Multiple operations or ot
her types of oper-
ations not described here
, especially the
blocking or disabling of o
perating devices,
can cause damage to the tru
ck but also
uncontrolled movements a
nd is therefore
prohibited.
• The driver can secure the truck against
unauthorised use by removing and taking
the switch key or by deleting the access
information on the electronic access control
system when leaving the truck.
• If required by the area of application and
work situation, the operator must use
suitable personal protective equipment
such as protective shoes, safety helmet,
protective gloves or industrial goggles.
The operator and operating company are
responsible for ensuring this.
• The openings in the gass
ingareaofthe
battery must not be cove
red or fully closed.
The unrestricted air su
pply is required
to prevent the formatio
n of potentially
explosive gas mixtures
.
• Under no circumstances should openings
be made in the battery’s gassing area,
which could allow the gas created during
charging to enter the area of the driver’s
compartment.
Operating safety is more important than
working speed!
52
13 804 2501 EN - 01/2016 11
To Next Page
Loading...
