4 Operation
General commissioning
Wheel screws
WARNING
Wheel screws may loosen after initial commissi-
oning.
After the first eight operating hours, tighten the
wheel screws to 195 Nm.
Support screws
CAUTION
Risk of accident as a result of the truck tipping over!
Support screws may only be adjusted by authorised
service personnel.
The basic position of the support screws must
correspond to the information on the load
capacity diagram.
The support screws in the chassis of the truck
areusedtoimprovestability.
The support screws may only be adjusted by
authorised service personnel.
If problems arise when the truck is operated
on uneven surfaces, the stability must be
recalculated by the manufacturer. It will then
be possible to increase the setting dimensions
for the support screws if necessary.
The truck will then be equipped with a new load
capacity diagram, on which the new setting
dimensions will be indicated.
WARNING
Risk of accident
The setting dimension for the support screws must
be checked every 6 months by authorised service
personnel and must be adjusted if necessary.
44
5213 804 2501 EN - 01/2016
To Next Page
Loading...
