Safety 2
Application area
Application area
The floor in the application area must have
sufficient strength to bear the weight of
the truck. The wheel loads / floor loads
specific to your truck will be made available
by your responsible sales representative.
The condition of the floor surface affects the
braking distance of the truck. The operator
must take this into consideration when driving
and braking.
The trucks described here are designed to be
used in areas (according to VDI2695, category
1)
• with flat and even floor with
out significant
slopes (below 3%)
• normal work load, 50% capacity utilization;
full load and half shift or half load and full
shift.
and ambient temperatures according to EN
1175-1.
WARNING
Restrictions in the applicational area.
The trucks described here must notbe used:
– in areas at risk from fire
– in areas at risk from explosions
– iin areas with atmospheres conducive to corro-
sion
– in atmospheres containing large amounts of dust
– in public traffic
– in refrigerated warehouses (see „special equip-
ment“Cold storage).
– on surfaces which are not horizontal.
The respective national regulations must be
observed.
52
13 804 2501 EN - 01/2016 19
To Next Page
Loading...
Need help?
General
