2 Safety
Intended use
Intended use
These industrial trucks are intended for
use in order picking applications, i.e. for
collecting parts that are stored in racking
systems, for example. This industrial truck is
therefore designated as a vertical order picker.
The forks must be equipped with suitable
load-carrying equipment in order to set down
the parts picked for the order. This process
is described in the section entitled Picking up
and setting down loads.
The industrial truck is not s
uitable for stacking
and unstacking unit loads in
storage systems.
DANGER
Risk of serious injury or death
When driving underneath solid structures (e.g.
rack bridge pieces, transfer stations or crossbars),
there is a risk that the operator may be crushed
and fatally injured between the racking and the
operating panel. This risk must be countered by
taking measures on site, such as using approach
rails for the load wheel arms.
It is the responsibility of the operating company
to identify and eliminate any danger areas and/or
to prohibit any reasonably foreseeable misuse by
issuing operating instructions.
The industrial truck is also suitable for raising,
lowering and transporting unit loads.
Use for other purposes is prohibited.
NOTE
There are also variants of this order picker
that have a walk-in order picking cage or an
order-picking platform instead of the fork.
The auxiliary lift can be moved to a height that
is ideal for setting down and collecting items
for order picking.
Observe the instructions in the paragraph
"safety".
The maximum load that can be lifted is speci-
fied on the loadbearing information plate (load
diagram) and must not be exceeded.
If these industrial trucks are to be used for
tasks not listed in these operating instructions
or in the guidelines for the intended use of in-
dustrial trucks issued by the VDMA (German
20
5213 804 2501 EN - 01/2016
To Next Page
Loading...
