Operation 4
Load pick-up
Load pick-up
Picking up and setting down loads
Picking up a load
NOTE
On this truck, a load is understood to be when
loading equipment is picked up on the fork to
collect items for order picking, as described in
the section entitled Intended use. Loads may
only be picked up and set down on flat and
horizontal surfaces
Drive the truck towards the loading equipment
and insert the fork into the fork pockets
provided. Insert the fork into the loading
equipment until the load/loading equipment
touches the back of the fork.
CAUTION
During this process, the load may be moved or even
knocked over.
Make sure not to jolt the fork.
Setting down loads
– Carefully approach the place at which the
load will be set down.
– Position the load as accurately as possible.
– Lower the load carefully until it rests se-
curely on the supporting surface.
– Lower the fork until there is sufficient free
space between the load and the fork.
CAUTION
Risk of damage to property
Do not place the fork on the supporting surface.
– Slowly drive the truck backwards so that the
fork is removed from the loading equipment.
– Monitor this process closely. The fork
position may be corrected by carefully lifting
or lowering the fork.
52
13 804 2501 EN - 01/2016 65
To Next Page
Loading...
Need help?
General
