Operation 4
General commissioning
Releasing the load wheel brake trans-
portation safety device*
A power supply is required to release the
load wheel brake. If there is no power supply
available (e.g. when transporting the industrial
truck without a battery), the load wheel brakes
must be released mechanically.
A notice regarding t
ransportation is fitted in
the driver’s compar
tment:
Prior to commissioning, release the load
wheel brake transportation safety device
In order to do this, use a suitable hexagon
socket wrench to release two screws in each
of the load wheel arms. Release the screws far
enough to allow the brake function to operate
correctly.
CAUTION
When commissioning, check that thebrake function
of the load wheel brake is operating correctly.
*Option
52
13 804 2501 EN - 01/2016 43
To Next Page
Loading...
