Installing an SNi40 model appliance on a DIN rail
To install the appliance in a cabinet, the SNi40 model has a fastener on a 35mm-wide DIN rail
(EN50022 standard).
REMINDER
Ensure that the cabinet complies with temperature and humidity conditions indicated in
the section Conditions of use. Equipment has to be installed by a qualified electrician.
NOTE
The SNi40 model has to be installed vertically.
The procedure is as follows:
l
Hold the SNi40 facing the DIN rail, then
insert the upper part of the rail into the
notch in the fastener. Set the SNi40 upright.
l
Push the appliance against the DIN rail
until you hear a click. Ensure that the
position of the appliance has been locked.
SNS - PRODUCT PRESENTATION AND INSTALLATION 2019
INSTALLATION IN A 19" CABINET AND RACK
Page 23/66 sns-en-SNrange_installation_guide-2019 - 09/2019
To Next Page
Loading...
