Studer Innotec SA
next3
Technical user manual V1.3 © Studer-Innotec SA 59
7.1.1
Screens map
The navigation on the nx-interface is organized as given by the picture below. A locked screen
appears after some time of inactivity on the nx-interface. It is unlocked with a slide move or with a
code. From the locked screen you go back to the last screen that was displayed before entering
sleep mode.
The main menu is always accessible form any screens with the icon: available on each screen.
The nx-interface screen is organized with screen levels
• LEVEL1: general view of the state of the energy system, the instant values, the history, and the
message log.
• LEVEL2: Information about each component (AC-source, Battery, solar,…)
Many detailed information that can be obtained from the next3 about the inverters
operation. For example the AC-reactive power of the phase 2 on the AC-source connection
can be seen by going on the AC-source from the main synoptic.
• LEVEL3: Programming: the settings about each component can be seen or modified.
Note: when on a configuration screen (Level 3), the settings are for a unique component. Per
exemple there are two solar mppt entries on one next, the settings are accessed individually.
For convenience and simplicity, not all information can fit on one screen. From the level
2, the “plus” button allows to access a list of detailed information.
From the level 3, the “plus” button allows to access a list of detailed settings.
On level one, the “plus” give access to the system settings.
The “plus” of level 2 and 3 is accessible at expert level only. The unique
reference identification number are used in communication and to clearly
identify the information/settings.
To Next Page
Loading...
Need help?
General