Studer Innotec SA
next3
6 V 1.3 © Studer-Innotec SA next3 Tech manual
3 GENERAL INFORMATION
3.1 ABOUT THIS USER MANUAL
This manual contains all the necessary information and procedures to install, configure, use and
troubleshoot the next3 hybrid inverters. It is the most detailed documentation about this product.
A summary is provided in the Quick Installation Guide, delivered with the product in a printed version.
Type of documents
It does not contain information about photovoltaic modules (PV) or batteries of various brands that
can be connected. For this kind of information, please refer to the instructions of each specific
manufacturer.
It does not contain specific information on national rules/regulations about electrical installation. It
contains only safety requirements about the use of the device next3 according to following
International and European standards; IEC/EN 62109 for power converters used in photovoltaic
systems and IEC/EN 62477 for power converters used in general systems.
General information that can help you for system design can be found in the Studer System Design
Book. Schematics and explanations for various specific cases can be found in “ next3 Systems design
: Application notes, typical configurations and schematics”.
This manual covers the next3 following models and accessories:
• Hybrid inverter charger (with any options) with software version up to 1.9.99
• Interface: with software version up to 1.9.99
• Battery temperature sensor:
This manual is an integral part of the equipment and must be kept available for
the operator and/or the installer. It is provided under digital form in the usb key
delivered with every unit.
The latest version of the manuals can be downloaded on Studer website:
https://www.studer-innotec.com
The content of this manual is copyrighted by Studer-Innotec SA, Rue des
Casernes 57, 1950 Sion, Switzerland
To Next Page
Loading...
Need help?
General