Studer Innotec SA
next3
8 V 1.3 © Studer-Innotec SA next3 Tech manual
not explicitly mentioned in this manual. Damages arising from the following causes are excluded
from the warranty:
•
Voltage higher than 900V across PV terminals.
•
Voltage higher than 70V across battery terminals.
•
Accidental presence of liquids in the equipment or oxidation due to condensation.
•
Damage resulting from falls or mechanical shocks.
•
Modifications carried out without the explicit authorisation of Studer Innotec.
•
Nuts or screws that have been too much or not enough tightened during the
installation or maintenance.
•
Damage due to atmospheric surge voltage (lightning).
•
Damage due to inappropriate transportation or packaging.
•
Damages due to improper installation
•
Disappearance of original identification marks.
3.3.2
Exclusion of liability
The installation, commissioning, use, maintenance, and servicing of the next3 cannot be subject of
monitoring by Studer Innotec. Therefore, we disclaim all responsibility and liability for damage, costs
or losses resulting from an installation that does not comply with the instructions, a faulty operation or
inadequate maintenance. The use of Studer Innotec equipment is in any case under the responsibility
of the customer.
This equipment is neither designed nor guaranteed to supply installations used for vital medical care
nor any other critical installation entailing potential risks of important damage to people or to the
environment.
We assume no responsibility for the infringement of patent rights or other third parties’ rights resulting
from the use of the inverter.
Studer Innotec reserves the right to make any modifications to the product without prior notification.
Studer Innotec is not liable for incidental, direct or indirect damages of any kind, including any profit
loss, revenue loss or damages caused to equipment or goods due to defective equipment.
To Next Page
Loading...
Need help?
General