Studer Innotec SA
next3
Technical user manual V1.3 © Studer-Innotec SA 69
7.3.2
Update
This part describes the update of the next system (inverters, nx interface and accessories) using the
nx-interface.
In the update screen, you can choose which source will the update come from:
• USB key: Download the latest software version from our website: https://www.studer-
innotec.com/en/downloads/ in the support and download section, unzip and copy the
whole folder called “next3-system-update” at the root of the key. The usb-key must not be
removed until the end of the updating process. If for some reason the updating process is
interrupted, restart it to let the process finish.
• Internet: The update via internet is not available and is a future feature for the next3. A new
button will appear when ready.
Press “search” for the source you want to use.
After the check, the screen tells you if an update is available. The current and the available update
can be seen on the right side. Information are displayed in case of incompatibility.
Once the update ready, you are informed of the available versions and you can start the update
of the system with the “Start Update” button.
The update is performed in many steps: first the nx-interface is updated and then you must press
again on the “start update” button for the next2 devices.
The updating process can take between 3 and 15 minutes. NEVER disconnect the
battery during an update. During this process, the installation is stopped and the AC
power supply is interrupted. Choose the proper moment to process an update
To Next Page
Loading...
Need help?
General