Sun Microsystems Sun SPARC Enterprise M5000 - Page 137

Chapter 2 Setting Up XSCF 2-85
3. Confirm the SNMPv3 trap settings.
Disabling Traps to the Target Host of SNMPv3
■ Command operation
1. Use the showsnmp(8) command to display SNMP settings.
2. Use the setsnmp(8) command to disable the trap destination host of the
SNMPv3 target.
3. Use the showsnmp(8) command to confirm that the trap destination host has
been disabled.
XSCF> showsnmp
Agent Status: Enabled
Agent Port: 161
System Location: MainTower21F
System Contact: musha@jp.fujitsu.com
System Description: DataBaseServer
Trap Hosts:
Hostname Port Type Community String Username Auth Protocol
-------- ---- ---- ---------------- -------- -------------
host3 162 v3 n/a yyyyy SHA
host1 62 v1 public n/a n/a
host2 1162 v2 public n/a n/a
SNMP V1/V2c:
Status: Enabled
Community String: public
Enabled MIB Modules:
SP MIB
FM MIB
XSCF> showsnmp
XSCF> setsnmp remv3traphost -u yyyyy host3
XSCF> showsnmp