Sun Microsystems Sun SPARC Enterprise M5000 - Page 142

2-90 SPARC Enterprise Mx000 Servers XSCF User’s Guide • August 2009
2. Use the setsnmpvacm(8) command to set VACM management information.
3. Use the showsnmpvacm(8) command to confirm the settings.
XSCF> showsnmpvacm
Groups:
Groupname Username
--------------- -------------------
xxxxx user1, user2
Views
View Subtree Mask Type
--------------- ------------------- --------------- --------
all_view .1 ff include
Access
View Group
--------------- -------------------
all_view xxxxx
<Example 1> Add a user to an access control group xxxxx.
XSCF> setsnmpvacm creategroup -u yyyyy xxxxx
<Example 2> Delete a user from an access control group xxxxx.
XSCF> setsnmpvacm deletegroup -u yyyyy xxxxx
<Example 3> Create an MIB access control view without conditions.
XSCF> setsnmpvacm createview -s .1 all_view
<Example 4> Create an MIB access control view by using an OID mask.
XSCF> setsnmpvacm createview -s .1.3.6.1.2.1 -m fe excl_view
<Example 5> Delete an MIB access control view.
XSCF> setsnmpvacm deleteview -s .1.3.6.1.2.1 excl_view
<Example 6> Provide an MIB access control view to a group.
XSCF> setsnmpvacm createaccess -r all_view xxxxx
<Example 7> Delete a group from all MIB access control views.
XSCF> setsnmpvacm deleteaccess group1
XSCF> showsnmpvacm