2-2 SPARC Enterprise Mx000 Servers XSCF User’s Guide • August 2009
■ COD Administration (optional) (see the following Note 4)
Note – (1) This document does not provide details on the remote maintenance
service function. For details on making settings and using the remote maintenance
service, refer to the manual describing the remote maintenance service in the
“SPARC Enterprise Mx000 Servers Documentation” on page xx.
Note – (2) Domain configuration is not required in the M3000 server. Some of the
options can be configured. For details, see Section 2.2.11, “Domain Configuration”
on page 2-94.
Note – (3) In the M3000 server, system board cannot be configured. System board
has been configured by default and you cannot change the setting. However, you
can refer to the system board information.
Note – (4) In the M3000 server, COD is not available.
After the XSCF is set up, the settings are automatically saved in XSCF internally and
in the operator panel. Once you have configured the XSCF, it requires no day-to-day
management. However, you can save or restore the XSCF setup configuration
information. For details of saving or restoring XSCF configuration information, see
Section 2.3, “Save and Restore XSCF Configuration Information” on page 2-145.
About Setup Flow
The XSCF Shell or XSCF Web can be used to set up XSCF.
Each setting items and the step summary are explained in Section 2.1.1, “Setup
Summary by the XSCF Shell” on page 2-3 and Section 2.1.2, “Setup Summary Using
the XSCF Web” on page 2-11. Details on each step in Section 2.1.1, “Setup Summary
by the XSCF Shell” on page 2-3 and Section 2.1.2, “Setup Summary Using the XSCF
Web” on page 2-11 are provided in Section 2.2, “Specifying the XSCF Settings” on
page 2-14.
To Next Page
Loading...
Need help?
General
