Website: www.sunsynk.com E-mail: sales@globaltech-china.com
51
IMPORTANT:
If you use the wind turbine with the Sunsynk inverter, you must ensure that the turbine matches the
specifications of the product. You need to use a Three-Phase p.m. type, with a running voltage of around
200V and a maximum voltage and power of 350V/400V and 5 kW, respectively. Moreover, we strongly
recommend using Automatic Self-Breaking Wind Turbines because when are fully charged and the inverter
is not exporting any power, the load can drop. This can cause the turbine to speed up dramatically, which can
be very dangerous and usually happens suddenly. Thus, it is essential to use a self-breaking turbine.
Figure 48 - Wind turbine with self-breaking.
To use the wind turbine, you need to set the wind turbine profile as presented in Figure
50. Again, DO NOT use a wind turbine that exceeds 350/400V.
Figure 50 - Wind turbine configuration.
Dump Load: When the battery (battery bank) is fully charged and the water turbine/wind turbine/ solar module
is still generating power, a dump load will provide the electricity a path to flow. This can be done using a
switch on the smart load option or utilising a wind turbine controller with a built-in dump load. Also, the hot
Figure 49 - Dump load.
Sunsynk.com Sunsynk.com Sunsynk.com Sunsynk.com
Sunsynk.com Sunsynk.com Sunsynk.com Sunsynk.com
Sunsynk.com Sunsynk.com Sunsynk.com Sunsynk.com
Sunsynk.com Sunsynk.com Sunsynk.com Sunsynk.com
Sunsynk.com Sunsynk.com Sunsynk.com
Sunsynk.com Sunsynk.com Sunsynk.com
Sunsynk.com Sunsynk.com
Sunsynk.com Sunsynk.com
Sunsynk.com
Sunsynk.com
Sunsynk.com Sunsynk.com Sunsynk.com Sunsynk.com
Sunsynk.com Sunsynk.com Sunsynk.com
Sunsynk.com Sunsynk.com Sunsynk.com
Sunsynk.com Sunsynk.com
Sunsynk.com Sunsynk.com
Sunsynk.com
Sunsynk.com
To Next Page
Loading...
