SUNWARD SWE155F - Work Mode Selection; Inspection before Starting Engine

OPERATION & MAINTENANCE MANUAL SWE155F
97
3.4.3 Work Mode Selection
 Based on different work condition, select different work
mode for the high efficiency, energy saving, and
environmental friendly purpose.
 Select different gears by accelerator rotary knob according
to driving modes, shown as below.
S─ medium load work mode
L─ light load work mode
H─ heavy load work mode
It’s a complete shift cycle
 The applicable work conditions corresponding to individual
work mode are as follow:：
3.4.4 Inspection before Starting Engine
Before starting the engine, do a walk-around inspection
covering the following items:
 Remove the dust on the cab windows to allow for a
good visibility.
 Remove all foreign matters around engine, radiator or
accumulator. Check for engine oil or fuel leakage. If
any abnormalities are found, clear them as well as to
Work
mode
Applicable work condition
S
Applicable for operations with
small load and high economical
efficiency requirements.
L
Applicable for operations with
light load, e.g. operation on flat
work ground.
H
Applicable for operations with
heavy load and demanding for fast
operation speed.
Mode Selection