OPERATION & MAINTENANCE MANUAL SWE155F
Change seat belt every 3 years to ensure the safety
performance of seat belt can meet the requirements for
use.
1.2.12 Ensuring Perfect Visibility
Stop the machine if the fog, rain, snow or dust has
negative effects on your visibility.
To work at dark, make sure the lighting device can
function normally.
1.2.13 Leaving Operation Seat Safely
Warning: Unexpectedly touching unlocked pilot
safety control lever can result in sudden movement of
the machine and cause injury or damages to the
machine.
When operator tends to leave or stand up off the
seat( to open or close front or upper windows, remove
or install front lower windows, adjust seat), please
lower the work equipment to the ground, set pilot
safety control lever to LOCK position securely, then
stop the engine.
1.2.14 Emergency Exit
If the door cannot be opened for some reason, you
may open the back windows, and use it as an
alternative exit way for emergency. For details refer to
the instructions in “emergency exit label”.
1.2.15 No Passengers Allowed
When machine is in the process of operation or
traveling, do not allow anyone to ride on the machine
other than the operator. Because there is a hazard that
passengers may fall off or get hit by foreign body.
Passenger may block operator’s sight to result in
unsafe operation.
Do not allow anyone to sit on bucket or other front
attachments. Serious injury can occur to person.
1.2.16 Worksite Safety
Thoroughly inspect worksite for any abnormal danger
situations prior to operation.
Operate with extra care for any operation in vicinity of
To Next Page
Loading...
