OPERATION & MAINTENANCE MANUAL SWE155F
cab to prevent fire as a result of solar light focusing.
Don’t leave lighter in cab. There is a possibility that
lighter may explode along with the increase of
temperature.
1.2.9 Correct Entering/Leaving Machine
Always face the machine, maintain a secure three point
contact to mount or dismount machine my means of
steps or handrails to avoid falling off.
Do not grip any control levers as a substitute of
handrails to mount or dismount the machine.
Keep all handrails, gangway clean and free of oil and
mud to prevent slip.
Never mount or dismount the machine while it’s under
the operation of tramping, swing, and digging.
Do not mount or dismount machine while holding tools
in your hand.
Do not jump on or off the machine.
1.2.10 Adjustment of Operator’s Seat
A comfortable posture can alleviate operator’s fatigue.
You may adjust seat for your comfort in relation to your
weight, height and arm length.
Distance from hand-lever: for ideal hand operation
posture, adjust distance of upper slide rail as well as
armrest angle and backrest tilting.
Position of pedal: for desired pedal operation posture,
adjust distance of lower slide rail as well as seat
height.
Weight support adjustment: adjust load bearing
capacity of seat in relation to your weight for better
damping effect.
1.2.11 Fastening Seatbelt
Check seatbelt for damage or wear out before starting
machine.
Fasten your seat belt prior to operation.
To Next Page
Loading...
