OPERATION & MAINTENANCE MANUAL SWE155F
3.4.9 Machine Traveling
Note
Only if the idler is under cab, the machine
moves in the same direction to the operation of
the travel levers.
When machine is traveling, do not change
traveling direction suddenly to avoid damages
to machine.
When starting the engine, set idler under cab. Then
place pilot safety lever to ON position.
Fold work equipment, lift boom, and keep the bucket
at a height of 400 to 500mm above ground level.
Push travel control lever or step down travel pedal：
push forward both travel control lever(or pedal) in
sync, the machine will move forward; pull backward
both travel control levers ( or pedal) in sync, the
machine will travel rearward.
The machine has two travel speed stages: high/low
speed, 5.5km/h and 3.5km/h accordingly.
When the sprocket is located under cab, push both
travel control levers (or pedal) in sync, the machine
will travel rearward. Pull backward both levers (or
pedal), the machine will travel forward. .
Note：
In real operations, it's difficult to identify the
relation between machine travel direction and
handle operate direction due to long-time operation,
you may give a trial operation by handling handle
slightly. With direction relation identified, you are
allowed to proceed to operate.
To Next Page
Loading...
