OPERATION & MAINTENANCE MANUAL SWE155F
4.5.1.2 Checking Engine Oil Level
Warning
The parts and oil are at high temperature after
engine is stopped, and may cause serious burns.
Wait until temperature goes down before
starting operation.
Open engine cover, pull dipstick out. Use clean rag to
remove oil trace on dipstick
Re-insert dipstick in position; pull it out to check the
oil mark. The mark should be between the lines of
MIN and MAX. if not, drain or refill.
If the oil level does not reach scale L, open port to
refill.
If the oil level overflows scale H, loosen drain plug to
drain redundant oil.
With oil level checked, insert dipstick into the hole and
secure port cover.
Note: The oil level checking operation should be
carried out 10 minutes after shut-down. If checking
oil level the moment machine has just been shut
down, incorrect number will be read.
4.5.1.3 Checking Coolant Level
Warning
There is high pressure in existence inside the
radiator, and coolant temperature is still high,
after engine is stopped. Do not open the refilling
port cover at this time. Wait until temperature
goes down, and then gradually loosen cover to
release pressure. Failure to do so will cause
serious burn.
Open left inspection door of the machine, inspect
coolant level of secondary tank. The level must be
between the lines of HIGH and LOW. If not, drain or
refill.
If the secondary water tank is empty, add coolant to
radiator first before adding coolant to secondary water
tank.
To Next Page
Loading...
