OPERATION & MAINTENANCE MANUAL SWE155F
4) Open bottom cover underneath engine, place container
under drain valve of engine oil pan. Open drain valve
to drain engine oil.
Note
The engine oil might be hot, be care to handle it
without being burned.
5) With engine oil drained, fasten and secure drain valve.
Replacing engine oil filter element
6) Oil filter is positioned on main pump chamber. Open
inspection door of main pump (right back door), use
supporting rod to secure inspection door.
7) Use special wrench for filter to remove filter cartridge
in counterclockwise manner.；
8) Clean up mounting surface of filter bracket base and
cartridge. Apply a layer of clean oil to new filter
washer.
9) Install the new filter, rotate filter cartridge clockwise
until washer is against bracket mounting surface. Be
sure that the washer is free of damage during the
process of installation.
10) Use special wrench for filter to rotate cartridge
clockwise for 3/4 or 1 turn.
Pay attention not to over fasten.
Replacing engine oil
11) Fill with oil through oil fill cap and check oil fill
volume until specific scale position on dipstick is
reached.
Engine oil capacity 25L
12) Cap oil filling port.
13) Start engine; run it unloaded at low speed for 5
minutes.
Check engine oil pressure indicator (red) on monitor
to make sure it goes off. If it’s still on, stop engine
immediately and identify the cause.
Check drain valve for any leakage.
Check dipstick for oil level.
To Next Page
Loading...
