SUNWARD SWE155F - Page 165

OPERATION & MAINTENANCE MANUAL SWE155F
158
the key from starting lock, set pilot safety lever to
LOCK position.
Note
 After completing work, the gear oil temperature
might be very high, wait for temperature to cool
down.
 Place a container under drain pipe to collect oil.
 Loosen drain plug to drain the oil, and then tighten the
plug.
 Remove oil fill end cover, add specified gear lubricate
oil.
 Remove dipstick of swing redactor, wipe off oil with
clean cloth, re-insert dipstick, then pull out again, the
mark of oil should be between two scales.
 If the oil level doesn’t reach mark L, add oil through
oil fill port, if the oil level exceeds mark H, drain
excessive engine oil and check oil level again.