OPERATION & MAINTENANCE MANUAL SWE155F
Note for safety
If the machine is installed with attachments or optional parts without the authorization of SUNWARD, its
service life will be shortened, and some machine failures or safety problems will be resulted in. Thus,
SUNWARD will not take any responsibility for any accidents or damages caused by the unauthorized
installation of attachments.
Warning
General note
● As the attachment is a powerful tool, it should be used correctly to avoid serious hazard or damage.
Don’t use the attachment before the instruction manual of the attachment is read thoroughly and
understood completely. If the instruction manual is lost, ask the attachment manufacturer or sales
company for a new one.
● Install a protective cover in front of the cab if a breaker or other attachments is installed. It depends on the
type of the attachment.
● Comparing to a machine installed with a bucket, the machine equipped with a breaker has a heavy load on its
front part, and the whole machine is not stable. Thus, when the breaker is rotated to one side, don’t operate
the machine to avoid tipping.
● After the attachment is installed, the swing range and gravity of the machine is changed, thus the machine
may move in a sudden, in that case, the status of the machine should be observed carefully.
● Before operation, a warning line around the machine should be placed to stop other people, Don’t operate the
machine when there’s people in the nearby.
● Don’t place feet on the operation pedal to prevent serious accidents caused by disoperation, except that the
pedal should be stepped during operation.
Note for assembly and disassembly
The procedures as below should be observed strictly for safe operation when disassembling and installing the
attachment.
● The operation of disassembly and assembly should be done on firm level ground.
● When the machine is operated by more than two persons, signals should be confirmed before operation and
observed.
● A crane should be used when lifting or moving a heavy object (more than 25 kg or 55 lb).
● Support the part firmly before disassembling. Pay much attention to the gravity position when lifting with a
crane.
● It’s very dangerous to operate the machine when lifting a load with a crane. A bracket is needed and make
sure it’s in a safe status.
● Make sure the machine is stable and will not tip over when laying down the dismantled attachment or
To Next Page
Loading...
