GENERAL INFORMATION 1-5
FUEL (For the other countries)
Gasoline used should be graded 91 octane or higher. An unleaded gasoline is recommended.
ENGINE OIL (For USA)
Use SUZUKI CCI SUPER 2-CYCLE MOTOR LUBRICANT or an
equivalent good quality synthetic based 2-stroke engine oil rated
FC under the JASO classification.
ENGINE OIL (For the other countries)
Use SUZUKI CCI SUPER OIL.
If they are not available, use a good quality 2-stroke engine oil
rated FC under the JASO classification.
TRANSMISSION OIL
Use a good quality SAE 10W-40 multi-grade motor oil.
BREAK-IN PROCEDURES
During manufacturing only the best possible materials are used and all machined parts are finished to a very
high standard. It is still necessary to allow the moving parts to “BREAK-IN” before subjecting the engine to
maximum stresses. The future performance and reliability of the engine depends on the care and restraint
exercised during its early life. Refer to the following throttle position recommendations.
• Keep to these break-in throttle position.
Up to 10 hours: Below
##
##
# throttle
To Next Page
Loading...
