5-28 CHASSIS
BRAKE SHOE
• Inspect the brake shoes for wear or damage. If any wear or
damages are found, replace the brake shoes as a set.
#
Replace the brake shoes as a set. Otherwise braking
performence will be adversely affected.
REAR AXLE
Support the rear axle using v-blocks and measure the rear axle
runout using the dial gauge as shown. If the runout exceeds the
service limit, replace the rear axle with a new one.
% 09900-20607: Dial gauge (1/100 mm)
09900-20701: Magnetic stand
09910-21304: V-block set (100 mm)
$ Rear axle runout
Service Limit: 3 mm (0.12 in)
REAR SPROCKET
• Inspect the sprocket teeth for wear. If they are worn as illus-
trated, replace the sproket and drive chain.
REASSEMBLY AND REMOUNTING
Reassemble and remount the rear suspension in the reverse or-
der of removal and disassembly.
Pay attention to the following points:
• Apply SUZUKI SUPER GREASE “A” to the rear axle bearings
and the rip of the dust seals before installing them.
For USA
& 99000-25030: SUZUKI SUPER GREASE “A”
For the others
& 99000-25010: SUZUKI SUPER GREASE “A”
Normal wear Excessive wear
To Next Page
Loading...
