ENGINE 3-17
CONROD SMALL END I.D.
Measure the conrod small end inside diameter using the dial cali-
pers.
If the conrod small end inside diameter exceeds the service limit,
replace the conrod.
% Conrod small end I.D.
Service Limit: 16.040 mm (0.6315 in)
' 09900-20605: Dial calipers
• When rebuilding the crankshaft, the width A between the webs
should be within the specified range.
% Crank web to web width A
Standard: 32.0 ± 0.1 mm (1.260 ± 0.004 in)
A
CLUTCH
CLUTCH SHOE
Inspect the shoes visually for chips, cracking, uneven wear, burn-
ing and check the depth of the grooves on the shoes. If there is no
groove at any part of the shoes, replace them as a set.
NOTE:
Clutch shoes must be changed as a set and never individually.
CLUTCH WHEEL
Inspection visually the condition of the inner clutch wheel surface
for scrolling, cracks, or uneven wear. Measure the diameter at
several points to check for an out-of-round condition as well as
wear.
% Clutch wheel I.D.
Service Limit: 87.50 mm (3.445 in)
To Next Page
Loading...
