CHASSIS 5-27
• Remove the rear axle bearings using the special tool.
% 09921-20240: Bearing remover set
• Remove the spacer 1.
INSPECTION
DUST SEAL
Inspect the dust seals for wear or damage. If any damages are
found, replace the tie rod with a new one.
BEARING
Wash the bearing with a cleaning solvent and lubricate it with
motor oil before inspection. Turn the inner ring and check to see
that it turns smoothly. If it does not turn quietly and smoothly, or if
there are signs of any abnormalities, the bearing is defective and
must be replaced with a new one.
BRAKE DRUM
• Inspect the brake drum and measure the brake drum inside
diameter to determine the extent of wear. If the measurement
exceed the service limit, replace the brake drum with a new
one. The brake drum inside diameter is indicated inside the
drum.
$ Brake drum I. D.
Service Limit: 110.7 mm (4.36 in)
To Next Page
Loading...
