ENGINE 3-21
• After the crankcase screws have been tightened, make sure
that the crankshaft, countershaft and driveshaft rotate smoothly.
• If their shafts do not rotate smoothly, try to free it by tapping
with plastic hammer.
GENERATOR ROTOR
• Install the generator stator 1.
NOTE:
Apply a small quantity of THREAD LOCK “1342” to the threads of
the screws.
"99000-32050: THREAD LOCK “1342”
• Fit the grommet 2 securely.
• Remove any grease from the tapered portion of the crankshaft
and also from the generator rotor.
• Install the generator rotor key 1 onto the crankshaft.
• Apply a small quantity of THREAD LOCK SUPER “1303” to the
threads of the generator rotor nut.
)99000-32030: THREAD LOCK SUPER “1303”
• Hold the generator rotor using the special tool and tighten the
generator rotor nut to the specified torque.
' 09930-40113: Rotor holder
# Generator rotor nut: 50 N
.
m (5.0 kgf
.
m, 36.0 lb-ft)
OIL GUIDE/BEARING RETAINER PLATE
• Install the oil guide/bearing retainer plate 1.
• Apply a small quantity of THREAD LOCK SUPER “1303” to the
threads of the screws.
)99000-32030: THREAD LOCK SUPER “1303”
To Next Page
Loading...
