1A-55 Engine General Information and Diagnosis:
P1651-H (Use of SDS)
Step Action Yes No
1 1) Remove the air cleaner box. Refer to “Air Cleaner Box
Removal and Installation in Section 1D (Page 1D-5)”.
2) Turn the ignition switch OFF.
3) Check the TO sensor coupler for loose or poor contacts.
If OK, then check the TO sensor lead wire continuity.
4) Remove the TO sensor.
5) Disconnect the TO sensor coupler.
6) Check the continuity between the R wire “A” and B/Br
wire “B”. If the sound is not heard from the tester, the
circuit condition is OK.
Special tool
(A): 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity test ( )
Go to Step 2. Br/W wire shorted to
VCC, or B/Br wire open.
I831G1110055-01
(A)
“A”
“B”
I831G1110057-02
To Next Page
Loading...
