1D-11 Engine Mechanical:
5) Remove the TP sensor (5).
NOTE
Prior to disassembly, mark the TP sensors
original position with a paint or scribe for
accurate reinstallation.
CAUTION
!
Never remove the throttle valve (6).
CAUTION
!
• Do not loosen the lock-nut (7).
• The fast idle screw (8) is factory-adjusted
at the time of delivery and therefore avoid
removing or turning it unless otherwise
necessary.
Assembly
Assembly is the throttle body in the reverse order of
removal. Pay attention to the following points:
• Apply a thin coat of engine oil to the O-ring.
• With the throttle valve fully closed, install the TP
sensor (1) and tighten the TP sensor mounting screw
to the specified torque.
NOTE
• Align the secondary throttle shaft end “A”
with the groove “B” of TP sensor.
• Apply grease to the secondary throttle
shaft end “A” if necessary.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
Special tool
: 09930–11950 (Torx wrench)
Tightening torque
TP sensor mounting screw: 2 N·m (0.2 kgf-m, 1.5
lb-ft)
NOTE
Make sure the TP valve open or close
smoothly. If the TP sensor adjustment is
necessary, refer to “TP Sensor Adjustment in
Section 1C (Page 1C-3)”.
5
I831G1140035-01
6
I831G1140038-01
7
8
I831G1140039-01
1
“A”
“B”
I831G1140040-01
I831G1140042-01
To Next Page
Loading...
