Engine Mechanical: 1D-52
Oil Strainer
• Install the oil strainer (1).
NOTE
Fit the convex part “A” of the oil strainer in
the concave part “B” of the crankcase.
Transfer / Rear Output Shaft / Rear Output Shaft
Bevel Gear
• Install the rear output shaft bevel gear (1) and rear
output shaft (2). Refer to “Transfer Removal and
Installation in Section 3C (Page 3C-3)”.
NOTE
Measure the backlash before installing the
transfer component parts (3). Refer to “Rear
Output Shaft Drive Bevel Gear Shim
Inspection and Adjustment in Section 3D
(Page 3D-11)”.
• Install the transfer component parts (3). Refer to
“Transfer Removal and Installation in Section 3C
(Page 3C-3)”.
Crankcase
• Wipe the crankcase mating surface (both surfaces).
• Insert the dowel pins (1) onto the left crankcase.
• Apply engine oil to the conrod big end and each gear.
• Apply bond to the mating surface of the right
crankcase.
: Sealant 99000–31110 (SUZUKI BOND
No.1215 or equivalent)
• Apply grease to the oil seals.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Assemble the crankcase with in few minutes.
“A”
“B”
1
I831G1140246-01
2
3
1
I831G1140247-02
1
I831G1140248-03
I831G1140252-01
I831G1140250-01
To Next Page
Loading...
