1D-53 Engine Mechanical:
• Tighten the crankcase bolts a little at a time to
equalize the pressure.
• Tighten the crankcase bolts to the specified torque.
NOTE
• Tighten the larger diameter crankcase
bolts first and then smaller ones
diagonally and evenly.
• Fit the cramp to the bolt “A”.
Tightening torque
Crankcase bolt (M6): 10 N·m (1.0 kgf-m, 7.0 lb-ft)
Crankcase bolt (M8): 26 N·m (2.6 kgf-m, 19.0 lb-ft)
• After the crankcase bolts have been tightened, check
if the each shaft rotate smoothly.
• Apply grease to the O-ring.
CAUTION
!
Use the new O-ring to prevent oil leakage.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Install the collar (2).
Gear Position Switch
• Install each gear shift switch contact and spring.
• Apply grease to the O-ring.
CAUTION
!
Replace the O-ring with a new one.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
“A”
I831G1140253-01
I831G1140255-01
I831G1140256-02
2
I831G1140258-03
I831G1140260-01
To Next Page
Loading...
